System Sensor’s i3™ series smoke detectors represent significant advancement in conventional detection. The i3 family is founded on three principles: installation ease, intelligence, and instant inspection.
FEATURES
-
Plug-in detector line, mounting base included
-
Large wire entry port
-
In-line terminals with SEMS screws
-
Mounts to octagonal and single-gang backboxes, 4-square
-
backboxes, or direct to ceiling
-
Stop-Drop ’N Lock attachment to base
-
Removable detector cover and chamber
-
Built-in remote maintenance signaling
-
Drift compensation and smoothing algorithms
-
Simplified sensitivity measurement
-
Wide angle, dual color LED indication
-
Loop testing via EZ Walk feature
-
Built-in test switch
Installation ease. The i3 line redefines installation ease with its plug-in design. This allows an installer to pre-wire the bases included with the heads. The large wire entry port and in-line terminals provide ample room for neatly routing the wiring inside the base. The base accommodates a variety of back box mounting methods, as well as direct mounting with drywall anchors. To complete the installation, i3 heads plug in to the base with a simple Stop-Drop ’N Lock™ action.
Intelligence. i3 detectors offer a number of intelligent features to simplify testing and maintenance. Drift compensation and smoothing algorithms are standard with the i3 line to minimize nuisance alarms. Two-wire i3 detectors needing cleaning can generate a remote maintenance signal, when connected to the 2W-MOD2 loop test/maintenance module, or to a panel equipped with the i3 protocol. This signal is indicated by LEDs located at the module and the panel. The SENS-RDR, a wireless device, displays the sensitivityof i3 detectors in terms of percent per-foot-obscuration.
Instant inspection. The i3 series provides wide-angle red and green LED indicators for instant inspection of the detector’s condition: normal standby, out-of-sensitivity, alarm, or freeze trouble. When connected to the 2W-MOD2 loop test/maintenance module or a panel with the i3 protocol, the EZ Walk loop test feature is available on two-wire i3 detectors. This feature verifies the initiating loop wiring by providing LED status indication at each detector.
Data Sheet
)
